2 d8b's boards and Power Supplys
Posted: Tue Mar 10, 2015 2:17 pmGood Morning!
Ive had a D8B for some time, and slowly Ive seen the unit go thru some issues, sliders stop working, freezing, needing to reboot to get use again, a bunch of different things happening. The current unit is a d8b with 5.1 and the power supply with a 300 mhz.
Because of the issue with the current d8b board, Ive looked around and found another d8b board and power supply, and had it sent here. Its also got 5.1, but a 160 mhz chip, so I wanted to continue to use the 300 power supply that I have currently, as another piece of software was also purchased and installed in the 300.
When connecting it all up, the 300 power supply to the "160" board, I get a msg that states the license isnt valid for this config.
Is there a way to get the newer board to see the license? Also on the 300mhz setup, I have also purchased mastering software, that Id like to use too.
Any way to get the mastering software and licensing off the 300 and onto the 160? Or is there a way to get the 5.1 licensing of the 300 to see the "160" board without the 160 powersupply connected.
Ive had a D8B for some time, and slowly Ive seen the unit go thru some issues, sliders stop working, freezing, needing to reboot to get use again, a bunch of different things happening. The current unit is a d8b with 5.1 and the power supply with a 300 mhz.
Because of the issue with the current d8b board, Ive looked around and found another d8b board and power supply, and had it sent here. Its also got 5.1, but a 160 mhz chip, so I wanted to continue to use the 300 power supply that I have currently, as another piece of software was also purchased and installed in the 300.
When connecting it all up, the 300 power supply to the "160" board, I get a msg that states the license isnt valid for this config.
Is there a way to get the newer board to see the license? Also on the 300mhz setup, I have also purchased mastering software, that Id like to use too.
Any way to get the mastering software and licensing off the 300 and onto the 160? Or is there a way to get the 5.1 licensing of the 300 to see the "160" board without the 160 powersupply connected.