d8b Forum

Dear Forum...its been a while since I have been here, but back again.

I have had no issues for the last 2 years with my d8b but now experiencing channel LED displays issues on Channels 1-12(25-36). When I boot-up, all the LED displays, including the 360 degree "clock pan divisions", remain on for Channels 1-12(25-36) until it finishes its boot-up sequence. Not sure if this an indicator of a board problem.?
The VU meters work fine for all channels and I have sound. Its just the Mute, Solo, Select or PAN displays for Channels 1-12(25-36) that do not work. I have checked all the cables inside a few times to insure they are well seated.
Removed cards, reseated plugs, cards etc.

OK, looks like it must of been a cable issue. I took all the cables out again, clean and reseated them . I even tied them down with plastic cable tie wraps around the BFC and main board to insure they did not pop out due to heat expansion....so far all good. Now back to music