d8b Forum

Hello,

Im having issues with my d8b. I had it for a few years and it never gave me problem until recently. I went ahead and did some reseach and set my BIOS, CMOS, INTERGRADED PERIPHERAL ect. back to recommended settings. I even replaced the motherboard battery then clean and reseated all my card on the board and cpu. Is there anything else I can do before I donate this board to the wind?


cpu error: Control Card not ready. Last Known State:Reset
Board Error: Error 43. Host did not boot

Try reinstaling the software for giggles.

Thank you. Ill give it a shot and ill let you know if that did the trick

Another thing that can cause strange oddities is wonky RAM. You might try reseating that or trying new RAM as well.

This is to blame for most problems that the table does not respond properly.

Clean with clean electronic contacts.
and try again