Page 1 of 1
Problem: no meter activity (Ver.3 software)
Posted:
Mon Mar 19, 2012 7:23 pmby FlametopFredVer2
Hello.
Using a d8b running Version 3 software.
What is weird is how good this board sounds in comparison to the older Version 5 board I was using.
However, just this weekend, I was playing multitrack (Alesis HD24) which has been fine.
Now there is nothing being heard, and no meter activity.
Any thoughts? I am pulling my hair out.
Re: Problem: no meter activity (Ver.3 software)
Posted:
Tue Mar 20, 2012 4:52 amby Casey_Pittman
You never stated your setup so trouble shooting will be tough to do until you have.
Till then, make sure the sample rates match between units.
-Casey
Re: Problem: no meter activity (Ver.3 software)
Posted:
Tue Mar 20, 2012 4:11 pmby Crash
Verify that is just the tape inputs that have gone away. Can you get a mic signal through the console?
Re: Problem: no meter activity (Ver.3 software)
Posted:
Fri Mar 23, 2012 12:54 amby FlametopFredVer2
tested with input - no signal coming in from inputs, from tapes ... no meter activity.
Everything "looks" normal in all the settings, all the connections.
I have torn out all my hair and now I am bald
Re: Problem: no meter activity (Ver.3 software)
Posted:
Fri Mar 23, 2012 2:03 pmby Crash
What is your clock card situation? Are you using the Apogee or the stock card? This sounds like a clock issue, like there is no clock signal.
Re: Problem: no meter activity (Ver.3 software)
Posted:
Sun Mar 25, 2012 8:31 amby SteveT
Sounds like time for the "ribbon cable connection correction" treatment!!
SteveT