Motherboard failure???
Posted: Wed Nov 25, 2009 7:07 pm
Hello,
Recently I unplugged my d8b without shutting it down first. When I powered it back up, I received the Error 43... Here is what I found after following the Error 43 recovery advice listed elsewhere on this forum.
1. The floppy light is always on, and destroys any disk I put into it. I replaced the floppy and now it works.
2. The Hard drive seems to have failed. I put it in a PC and it claims that it is unformatted. I replaced it with a 20Gb drive.
3. After close inspection, I noticed that the top of one of the capacitors on the motherboard was bulging open. It looks like it may have failed. Bad Motherboard?
4. So then I tried to reinstall the OS. When loading the first disk, the following is flashed briefly (I had to use a video camera to read the subliminal message):
------------------------
-- Mackie OS Loader V3.0 --
Starting in Real Mode
Enabled A20
In Protected Mode
Heap Init
0010FFF0 to 87FFFF18 <-- not sure if this is right
Remove disk and press esc key to reboot
loading application
---------------------------
This is followed by:
----------------------
Starting TCP/IP Socked Layer
GENERAL PROTECTION FAULT
GENERAL PROTECTION FAULT
GENERAL PROTECTION FAULT...(repeated down the screen.)
-----------------------
So,
Any ideas?
Is there any one who could sell me a replacement CB50-BX motherboard for less then the $300 that Mackie is charging?
Am I missing something obvious?
Thank you for any advise,
Jim Anderson
Recently I unplugged my d8b without shutting it down first. When I powered it back up, I received the Error 43... Here is what I found after following the Error 43 recovery advice listed elsewhere on this forum.
1. The floppy light is always on, and destroys any disk I put into it. I replaced the floppy and now it works.
2. The Hard drive seems to have failed. I put it in a PC and it claims that it is unformatted. I replaced it with a 20Gb drive.
3. After close inspection, I noticed that the top of one of the capacitors on the motherboard was bulging open. It looks like it may have failed. Bad Motherboard?
4. So then I tried to reinstall the OS. When loading the first disk, the following is flashed briefly (I had to use a video camera to read the subliminal message):
------------------------
-- Mackie OS Loader V3.0 --
Starting in Real Mode
Enabled A20
In Protected Mode
Heap Init
0010FFF0 to 87FFFF18 <-- not sure if this is right
Remove disk and press esc key to reboot
loading application
---------------------------
This is followed by:
----------------------
Starting TCP/IP Socked Layer
GENERAL PROTECTION FAULT
GENERAL PROTECTION FAULT
GENERAL PROTECTION FAULT...(repeated down the screen.)
-----------------------
So,
Any ideas?
Is there any one who could sell me a replacement CB50-BX motherboard for less then the $300 that Mackie is charging?
Am I missing something obvious?
Thank you for any advise,
Jim Anderson