FL Studio & Probox

[samewon]

Has anyone had any success with making it work?

I played around and I managed to get transport to work but channels (on the d8b) 1-8 and 9-16 was identical and only controlling channel 1-8 in FL.

Channels 17-24 on the d8b were switchable, I could switch FL channels and make it control all the way up to 99. I used the "1-24" and "25-48" buttons on the d8b to scroll channel "banks"

[munkustrap]

Hi

on all DAWs there are two possibilities to get that stuff running.

1. Put all 3 MCu/XTs into one Controller Group ,
OR
2. enter channel Offset in steps of 8,16

so in your case I would expect that you have two Controller Groups and/or wrong Offsets of the channels.
can you provide screenshots of the Controller Setup ?

best regards

[samewon]

This what the midi settings looks like.
If you are using a Mackie MCU with fl studio it is not possible to use an XT.

[munkustrap]

As Controller type use Mackie MCU instead of generic.
can you make a screeenshot of all available Controller types ?

if you do not have XTs you can configure your probox to emulate 3 MCUs (Page 3 of probox Setup)

alternative you can Switch the probox to HUI mode and use 3 HUI Controllers.
Note that you use MCUPort2-4 !

[samewon]

Here are the controller types.

[munkustrap]

Hi
I've checked the FL Studio online help.
seems so that there is really not the possibility in FL to go up to 24 chans.
I will download a FL demo (they have one) and will try, but I will be on a Business tripnext week so I can try in in 10 days.

best regards

[samewon]

Okay.
Thank you for the help!

[munkustrap]

Hi

i tried now with the demo Version. It's not possible to get that running. I made a Special Firmware to emulate 3 MCU instead of 1 MCU and 2 XT but also there I had no success. I will ask the FL Support how to do or if there is a Chance to get that running.

best regards
Munk

[munkustrap]

Hi

FL Studio has a really bad Support. I can only post to a Forum and this with a registered product (I only have the demo)
may somebody who has a Forum account can post to the FL Controller Forum that 3 MCU (Mackie Controller) cannot be used in a 24 channel configuration (all 3 MCU Show channel 1-8). As it is possible to configure 3x MCU this is a bug of FL in my Point of view.

[samewon]

I now have a registered account at the image-line forum.
I will post the question about adding 3 MCU.

I wonder if doing the midi mapping yourself is some kind of solution to the problem?
See this video:

[Youtube]https://www.youtube.com/watch?v=5lTDnAx0sgE#t=71[/Youtube]