booting/wordclock issue

[krstudio]

Recently I accidentally changed my Apogee to 192 and the D8B went crazy. Shut it down and reboot but didn't lock so booted again. Everything is fine. Next time I boot up I get no signal. The software loads no issue but I get no digital or analog signal. I clean and re- seat all the cables and still have the same issue. I try a different Apogee card and the same happens. I put in the original WC card and it boots up fine and digital and analog is fine. I go back to either Apogee card and it's a no go. Any ideas?

[bbb]

Try deleting the startup file.

[krstudio]

Thanks for the tip! I tried it but no luck. I am beginning to think I fried the Apogee cards. The original works just fine, but limits my setup. Any other thoughts from the gurus?

[anyhorizon]

What do you mean by "either" Apogee card? Are you referring to the DIO 8 cards and not the Apogee clock card? Have you reset the clock source to external?

Peter

[krstudio]

I have the original WC card plus the Apogee card which I upgraded and I had a spare. Only one at a time is being used, I know my reply could be taken as using several improperly at the same time.
Is it possible to fry the Apogee WC if it got hit by 192k by accident?

[anyhorizon]

I don't think so. It just wouldn't recognize it. Try running your board with the Apogee WC card set to internal.

Peter

[anyhorizon]

Just to be sure of what you're talking about... Do you have an Apogee Word Clock card in the Sync slot or are you thinking that the DIO 8 card is the Apogee word card because it has Apogee printed on it?

Peter

[krstudio]

It's the Apogee in the sync slot. My other slots are ADAT i/o. Nothing has changed on my system for 5 or 6 years. I did put the apogee card back with WC in from my sound card. Under settings I can not find a place for internal/external or WC settings. I can pick between 32/NA, 44.1 or 48. Again no analog in or out functioning. I am still using V3. In the past IIRC WC automatically set to external if WC was present. Am I remembering incorrectly?
Thanks for the help BTW!

[anyhorizon]

Under the setup window, on one of the pages, you'll find a setting where you can change W/C to internal. Try internal.

Peter

[anyhorizon]

Also. as crash has previously recommended, with the monitors turned down, toggle back and forth between 44.1K and 48K finally settling on what your preference is.

Peter