Changing an Input trim pot

[funk]

AHH maintenance time,,,, i have been putting this off for 7 years,
1) Has anyone changed an Input trim pot ? and are these just a generic readily available one?
i have had one on chan 4 needing replacing since i have had it.
the chan 4 meter is just jumping up and down when i hold the pot to one side its fine.
Its just anoying i cant use that chan.

2) one of my select buttons chan 15 and the one above the HI/MId pot, below the LCD does not work so both needs a new micro switch, are these just normal micro switches ?

Any help befor i attack it would be great

[Crash]

Somewhere there is a build of materials that would give you that info. I am looking for it but can't find it as of yet. I am sure someone else will be along shortly to steer you in the right direction. Sounds like a broken solder joint to me, you may be able to tack that down with replacing the pot but you won't know until you get in there.

[anyhorizon]

The BOM is included in the schematics post in the database and the service manual post that follows that in the database.

Peter

[Crash]

I knew it was in there somewhere...I kept looking and just missed it.

[funk]

Cheers pete/crash... Again,
I knew about them, i just thought someone might have done it already,
yes it does seem like a solder joint,
i did not want to strip things off i dont have too just for a pot, the micros i can live with.
and wanted the parts ready befor i strip it down,
has any one got a pic of the 10k pot ?
or know whar sort it is ?